Nine precautions for using the hottest saw blade

2022-08-24
  • Detail

Nine precautions for the use of saw blade

precautions for the use of saw blade:

1 Please hang the alloy saw blade vertically on a dry shelf, and be sure to avoid wet places. Do not put the alloy saw blade horizontally on the ground or shelf, which will cause the deformation of the alloy saw blade

2. When using, do not exceed the specified maximum speed. The speed calculation method is attached for reference

3. When using, you must wear protective covers, gloves, safety helmets, labor protection shoes and protective glasses

4. When installing the alloy saw blade, you must first confirm the performance and purpose of the saw table, and it is best to read the instructions of the saw table first. In order to avoid accidents caused by wrong installation

5. When installing the alloy saw blade, you must first check whether the alloy saw blade has cracks, distortion, leveling, tooth loss and other phenomena before installation

6. The saw teeth of the alloy saw blade are extremely hard and sharp. It is forbidden to collide and fall on the ground. At the same time, the relative repeatability of the range of circulating torque and the relative repeatability of the peak value of circulating torque must be handled with care according to the requirements of 1%

7. After installing the alloy saw blade, it must be confirmed whether the central hole of the saw blade is firmly fixed on the flange of the saw table. If there is a gasket, the gasket ring must be well covered; Then, gently push the saw blade by hand to confirm whether the saw blade rotates eccentrically and shakes

8. The cutting direction indicated by the arrow of the alloy saw blade must be aligned with the rotation direction of the saw table. It is strictly forbidden to install in the opposite direction, because the wrong direction will lead to tooth loss

9. Therefore, we pay more attention to this model when recommending it to users: after replacing the alloy saw blade, it needs to be rotated for one minute before use, and cutting can be carried out when the saw table is in working state

Copyright © 2011 JIN SHI